Delfield SSR2-SH Manual de instalación descargar pdf (Pagina 8)

Supremacy Series

Reach-Ins Service and Installation Manual

For customer service, call (800) 733-8829 or (800) 723-8948, Fax (989) 773-3210, www.deleld.com

Supremacy Series

Reach-Ins Service and Installation Manual

For customer service, call (800) 733-8829 or (800) 723-8948, Fax (989) 773-3210, www.deleld.com

Electrical connection

Refer to the amperage data on pages 3-7 or the

serial tag data and your local code or the National

Electrical Code to be sure the unit is connected

to the proper power source. A protected circuit

of the correct voltage and amperage must be run

for connection of the supply cord or permanent

connection to the unit. The power must be

turned off and disconnected whenever performing

maintenance or repair functions.

Permanently connected units must be connected in

accordance with NEC Article 422 Appliances.

C-Disconnecting means. It is the responsibility of

the end user to provide the disconnect means to

satisfy the authority having jurisdiction.

Large cabinets should always be moved with

extreme care and caution.

Location

Units represented in this manual are for indoor use only. Be sure the

location chosen has a oor strong enough to support the total weight

of the cabinet and contents. Allow for a total load of approximately

600 pounds (273kg) per door section. Reinforce the oor if necessary

to provide for maximum loading. For the most efcient operation, be

sure to provide good air circulation inside and out.

Inside cabinet: Take care not to block air ow to the fans or heating

elements and allow space along the front, back and sides.

Outside cabinet: Be sure that the unit has access to ample air; avoid

hot corners and locations near stoves and ovens. Always provide a

minimum of 12 inches (30.5 cm) of clearance above the unit that is

open to the front.

If the doors need to be removed during installation: Remove top

hinge cover, remove screw with Allen wrench. Then remove the

spring tension nut, then the door can be lifted and removed.

Leveling

A level cabinet looks better and will perform better because the doors

will line up with the door frames properly, and the cabinet will not be

subject to unnecessary strain.

Stabilizing

It is very important that all legs are properly adjusted to keep the unit

level, evenly distribute the weight and to make sure the unit will not

rock, lean or be unstable.

The cabinet must be installed in a stable condition with casters locked

when unit is in use.

INSTALLATION REACH-INS AND PASS THROUGHS

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comentarios a estos manuales

Sin comentarios

Delfield SSR2-SH Manual de instalación Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Neveras Delfield SSR2-SH